Note: Please make sure that you have set FACTORY SETTINGS in cylinder before you send
it to us for repairment.
5.3 Verify deletion
Short press the "RESET" button once (1x).
6.0 Locking time
Short press the "SET" button eight times (8 x). You need to verify Admin fingerprint, then screen
shows you how many seconds is present locking time (8 seconds).
Shortly press "SET" button if you want to increase locking time, one press is one second increase,
etc.
The door lock motor reverse time is set successfully. Shortly press the "RESET" button.
7.0
Language setting
Short press the "SET" button SEVEN TIMES (7 X). You need to verify Admin fingerprint, then
system enters
Language setting
automatically after 2 seconds. S
Shortly press "SET" button, the screen will show and change “Chinese” and “English”
Press SET button once (1 x) for Chinese, press twice 2 x to get back to English language.
8.0 Unlock operation
The user put the finger on the fingerprint sensor directly, system will sound a wonderful music. If
matched successfully lock will open for 8 seconds to enable user to enter the room.
System will beep in quick intervals if fingerprint was not recognized. User should verify fingerprint
again, or use next registered finger.
Good to know tips:
Please gently press finger to scanner surface by touching wireless symbol to wake up the system
and ensure fingerprint authentication process. Please keep fingerprint surface flat so that reader
can generate image of your fingerprint skin and make encrypted code out of it. This code is then
stored in system memory. Note: fingerprints will stay in PCB even if batteries run out because
system uses flash memory.
