19
20
Care instructions
Care instructions
5.1 Removing the 5-point harness system and cover
5.2 Refitting the 5-point harness system and cover
Adjust the shell to the inclined position (3-A/3-C), pull the
(4-A), push down the adjusting device and
pull out the Belt yoke from other side to unlock it (5-A), pull the
(5-B), pull the shoulder belt out
from the hole (5-C).
Loosen the bottom part of the cover and pull the belt clip through the elt
clip slot (5-D). Then pull the buckle clip through the
clip slot (5-E).
Remove 5-point harness system then remove the headrest cover and the
shell cover (5-F).
Lower shaft out
and pull the seat shell towards
Shoulder
belts Axle out, untie the Shoulder belt
b
buckle
5-A
5-B
5-C
5-G
5-H
5-I
5-J
5-K
5-L
After washing, place the cover on the shell (5-G).
Loosen the bottom part of the cover and pull the belt clip through the elt
clip slot (5-H).
Then pull the buckle clip through the
clip slot (5-I).
Put the end of the Shoulder belt through the
shell, fix into
(5-J).
Also put the end of the Shoulder belt through the
shell, fix
into the Belt yoke
5-K), make sure the seat belt can not rotate.
Close the buckle (5-L), then fasten the cover all around, behind the pins,
check that it works! .
（
b
buckle
Belt slots and
Shoulder belts Axle, and lock the Shoulder belts Axle to the seat shell
Belt slots and
5-D
5-E
5-F