welldana WMV, Инструкция по эксплуатации

Страница: 12 / 29

9
2.1.5 Check and set parameters
When heat pump is in standby status, press button for 5 seconds display will
MODE
show parameter number with value flashing together.
Move “+” and “-” button to check required parameter
settings.
Select desired parameter and press button
MODE
for resetting parameter. Parameter number stays
fixed while parameter value remains flashing.
Move “+” and “-” button to adjust the value.
Press button to confirm the setting.
MODE
Without any further movement on the display button
in 2min it will return to main interface automatically.
See Parameter table for more details.
parameter
value
Note: All parameters can be changed ONLY under standby status !
2.1.4 Adjust desired water temperature
1.First select desired mode, auto, heating or cooling.
2.No matter the heat pump is under standby status or running status, press “+” or “-” , display will
show the desired water temp. of selected mode with a flashing value, then change the water temp.
by moving “+” or “-” as requested.
Figure 2-5
Press button 5s in a quick stop to activate time setting. TIMER
When hour numbers are flashing it is available for revision, move “+” or “-” to fix hour numbers.
Press button to confirm hour setting. TIMER
Minute numbers start flashing once the hour numbers are confirmed, move “+” or “-” to fix minute numbers.
Press button to confirm minute setting. TIMER
TIMER
TIMER
TIMER
2.1.6. Setting Time