welldana 34-180505, Руководство пользователя

Страница: 24 / 28

Parameters.
The control has 11 parameters from 00 to 10.
Using the set button will scroll the parameters for control without stopping the heat pump.
The parameters cannot be changed here.
Parameter Description. Range. Standard Setting. Remarks.
00 Setting of cooling temp. 8 – 28ºC 28ºC To be set by user
01 Setting of heat temp. 15 – 40ºC 28ºC To be set by user
02 Defrosting period 30 – 90 min. 30 minutes. For technician only
03 Coil temp. start defrosting 0 ~ -30ºC -3ºC For technician only
04 Coil temp. stop defrosting 2 – 30ºC 13ºC For technician only
05 Defrosting time. 1 – 12 min. 8 minutes. For technician only
06 System number. 1 – 2 1 May not be changed
07 Re-start after power failure 0 / 1 1 = ja. For technician only
08
Work type:
Cooling = 0
H cooling = 1
Heating = 3
0-1-2-3 1 For technician only
09 Work method. 0 – 1 0 May not be changed
10
Setting of water temp.
(auto mode )
8 – 40ºC 28ºC For technician only
Push start , the compressor and blower will stop.
The control has now been put on standby.
Only in standby may the parameters be changed.
The display shows the following which is the introduction to the
parameters.
See picture right.
Push set, and parameter 00 will appear.
Pushing again, continuing to parameter 01 etc. until all the
parameters have been scrolled through.
Push arrow up / arrow down to change the setting.
Close by pushing start. The control will now remember the
setting.
The heat pump will now start automatically after 2.45 minutes.
You may refer to the parameters in the display on the next
page.
Parameter 01 is the setting for required pool temperature.
The standard setting for the pool temperature is 28ºC
Parameter 00 and 02 to 10 are settings for technician only.
When the heat pump has registered the required water / pool temperature on the inlet in the heat pump, the
heat pump will stop automatically. The heat pump has 1ºC of temperature difference.
If the temperature drops, the heat pump will start automatically.
If the control is required to be locked, act as follows:
Push arrow up and arrow down simultaneously, and keep them in for 5 secs.
The control panel will then have been locked.
A lock will appear in the display.
Push arrow up and arrow down simultaneously, and keep them in for 5 secs.
The control panel will then have been unlocked.