Wella XPERT HS 71, Инструкция пользователя, Страница: 13 / 150

11 ENGLISH
3.3 Switching ON /OFF
• In order to switch the appliance off, press the On/Off switch 3. The charge sta-
tus display 6 lights up.
• In order to switch the appliance off, press the On/Off switch 3 again. The
charge status display 6 goes off.
3.4 Adjusting the cutting length
The cutting length can be set to three levels.
Image G: push the lever 5 into the desired position:
l: 0.5 mm
ll: 1.5 mm
lll: 2.5 mm
3.5 Comb attachments
The comb attachments 14 with the lengths 4, 8, 12, 16 and 20 mm can be put on
the cutter head 4 .
Please observe: the cutting length of the comb attachment and the cutting length
set on the appliance are added up together.
Example: comb attachment 20 mm and lever 5 on position III (2.5 mm) result in a
cutting length of 22.5 mm.
1. Image H: switch off the Wella Professionals Xpert and push the desired comb
attachment onto the cutter head 4.
2. Then you can cut hair as usual with the Wella Professionals Xpert .
4 Cleaning and care
CAUTION:
To ensure faultless operation the cutter head must be regularly cleaned and oiled
in the appropriate places. If you do not regularly clean the cutter head, this leads
to an increased wear of the cutter head and motor.
Cleaning the cutter head
With regular use the cutter head 4 should be cleaned thoroughly once a day .
1. Switch off the appliance.
2. Image I: from above, press against the cutter head and remove it from the hair
clippers.
3. Carefully remove the hair with the cleaning brush 13.
4. Image J: press the upper and lower knife slightly apart and remove the hair in
the gap using the cleaning brush.
NOTE: the lever 5 for the cutting length adjustment allows you to move the upper
and lower knife away from each other.
Oiling the cutter head
In order to preserve the cutting performance of the cutter head 4 as long as possi-
ble, the cutter head must be oiled regularly – ideally once a day .
1. Remove the cutter head.
2. Image K: oil the areas where the bottom and top shear blades touch.
3. To allow the oil to spread well, let your Wella Professionals Xpert run for about
20 seconds. - You can continue to work while doing so!
Putting on the cutter head
1. The appliance must be switched on.
2. Image L: first, place the cutter head with the bottom part first into the appliance
and then press it upwards with one swivel movement. Do not use force. The
engagement of the cutter head must be audible.
Cleaning the appliance
• From time to time, wipe the appliance with a slightly moistened cloth, then rub
dry.
Cleaning the charge contacts
If the charge contacts 2 on the appliance or the charge contacts 7 on the battery
charger are dirty, the charging may be interrupted or obstructed.
• Clean the contacts with a piece of cotton wool or cloth, dipped in alcohol or
methylated spirit.
U24_Wella_Xpert.book Seite 11 Mittwoch, 29. Oktober 2014 4:07 04