FEATURES
Current charging status for each battery is shown by the number of LEDs alight
Charging is automatically stopped when the battery is full, using –ΔV technology for NiMH batteries and
constant charge current technology for Li-ion batteries
In addition, there is a temperature sensor for stop over-heating
The charger will detect faulty batteries and will not charge them
When normal charging is completed, the unit will switch to a trickle charge to ensure maximum battery
run-time
When 1 or 2 Li-ion batteries are put in the charger, it can be used to charge your USB devices (mobile
phones, tablets etc) by using the USB port
SPECIFICATIONS
Input:
AC 100-240V 50/60Hz
Output:
4.2V 500mA*2
DC 12V 1.5A
1.48V 500mA*2
USB 5V 1000mA
COMPATIBILITY
3.7V Li-ion batteries: LIR26650, 22650, 26500, 18650, 18490, 17670, 17500, 17335, 16340, 14500, 10440
1.2V NiMH batteries: A, AA, AAA, AAAA, C, SC
LED INDICATOR
Connect the charger to the mains power.
The LEDs in each channel will light up, from the bottom to the top.
Place 1 or 2 batteries in the charger checking that the polarity is correct. (+/-) and they are
securely placed.
The LEDs will start to flash from the bottom up, then stay fully on. When the top light stays
fully on, the batteries are full and the charger will switch to trickle charge. Then remove the
batteries from the charger.
If all three light flash simultaneously, remove the batteries immediately as they may be
defective or the polarity may be wrong.
USB POWERBANK FUNCTION
When the power cord is disconnected from the mains, the charger becomes a Powerbank and you can
charge your USB devices (mobile phones, tablets etc) using your standard USB cable.
With 1 Li-ion battery the USB output is 1000mA. With 2 batteries is 2000mA. In both case the voltage is
5V.
Note: This function does not work with NiMH batteries in the charger, only with Li-ion batteries.
