WELDY miniwelder geo2, Руководство по эксплуатации

Страница: 9 / 96

9
Please read operating instructions carefully before use
and keep for further reference.
Operating instructions
(Original operating instructions)
WELDY miniwelder
Automatic Welder
GB
DANGER!
Danger when opening up the tool, as components and connections are ex-
posed. Therefore, before opening it, unplug the tool to ensure disconnection
from the mains.
Danger of fire and explosion! Incorrect use of the automatic welder (e.g.
overheating of the material) can present a fi re and explosion hazard, especially near
combustible materials and explosive gases.
Danger – can cause burns! Do not touch bare metal parts and emerging
material while hot. Allow the device to cool down.
Warning
The tool must be operated under supervision. Heat can ignite flammable
materials which are not in view. The machine may only be used by qualified
specialists or under their supervision. Children are not authorized to use
this machine.
For personal protection on building sites we strongly recommend the tool be
connected to a RCCB ( R esidual C urrent C ircuit B reaker).
Protect tool from damp and wet .
FI
Caution
The voltage rating stated on the tool must correspond to the mains voltage.
In case of a power loss, the potentiometer drive speed (12) and potentiometer
heating (15) had to be set to 0.
230
400
Only connect the tool to a receptacle with protective earth conductor. Any dis-
connection of the protective earth conductor, in or outside the tool is dangerous!
Use line/mains extension cables with protective earth /ground conductor
and adequate cross sectional area only!
While working on the open system avoid wearing garments such as shawls,
scarves and ties. Long hair must be tied or protected by headgear.
Moving parts may not be touched. The danger exists of inadvertently becoming
caught and being pulled in.