Weldforce 155
M &
175
MST
© Weldclass 2020 | E.&O.E.
15
7
BASIC OPERATION
7.1
MIG Welding
WARNING!
Before changing the feed roller or wire spool, ensure that the mains
power is switched off.
7.1.1
Fitting Wire Spool
1.
Open the wire feeder compartment door.
2.
Remove the Tension Nut & Spring
3.
Remove Flange/Spacer
4.
Fit the wire spool to the Spool Post Bolt, ensuring that the wire spool is position so that the wire
will exit from bottom of spool.
5.
Replace the Flange/Spacer – as per orientation shown below (orientation is different for
100mm/1kg vs 200mm/5kg spools)
6.
Replace spring & Tension Nut.
Note: Adjust tension so that the spool can rotate freely, but does not continue to rotate (free-
wheel) once the wire feed stops.
Figure 7
Содержание Weldforce 155M
Страница 29: ...Weldforce 155M 175MST Weldclass 2020 E O E 29 Weldforce 155M Figure 16 ...
Страница 30: ... 30 Weldclass 2020 E O E Weldforce 175MST Figure 17 ...
Страница 36: ... 36 Weldclass 2020 E O E Figure 25 Figure 26 Figure 27 Figure 28 ...
Страница 68: ... 68 Weldclass 2020 E O E www Weldclass com au ...