Welch Allyn 35900-NP-TE, Инструкция по применению

Страница: 50 / 71

Status/Error messages
Display messages
Message Definition
Attach Probe No probe is detected at the start of a test.
Device not Responding The printer is not responding to queries from the instrument.
Wireless Device Not Found
The paired wireless device cannot be detected by the screener.
The screener may be turned off or too far away.
Wireless Error #xxx.
There is an error condition with the wireless device. Check the
status.
Wireless Not Configured
The screener is not paired with any wireless device.
Fit Error Cannot Obtain P For a DP test, the desired intensity level (L1 or L2) cannot be
obtained within allowable limits. Refit the eartip and probe and
attempt the test.
Fit Error Too High The level of the calibration tone is too high. Refit the eartip and
probe and retry the test.
Fit Error Too Low The level of the calibration tone is too low. Refit the eartip and
probe and retry the test.
Limit Error Overflow error during the calculation of the DFTs for a DP test.
Repeat the test.
Memory Almost Full Saved tests are within 5 tests of the 250 maximum limit.
Memory Full! The maximum saved test limit of 250 is reached. Clear the
memory before any additional tests can be performed.
Power Low! The battery charge level is too low for operation. Charge the
battery in order to administer additional tests.
Printer Error There is a problem with the printer. Check the printer status.
Printer Paper Out! The printer paper has run out. Load printer paper.
Time/Date Error The clock is checked during power on to ensure it has not lost
time and been reset. In the case of clock reset, this message is
shown. Set the correct date/time.
46 Troubleshooting Welch Allyn
®
OAE Hearing Screener