Welbilt Kolpak HAL-C2-N1, Оригинальное руководство по установке, эксплуатации и техническому обслуживанию, Страница: 5 / 16

5
Section 2
Installation
Air Shield Installation
• Check the selected installation location to ensure that racks, braces, conduit, etc. are not in the way to properly mount
the Air-Sheild.
• To attach Kolpak Air Shield to wall on inside of Walk-in cooler, use the 8 screws provided in packet under shield cover.
•
Remove screws along both outside edges of cover to remove cover assembly. Stand base assembly vertically adjacent
to edge of inside doorjamb and remove the tape backing; align with edge of door jamb and secure using the 8 screws
provided to attach the base to the jamb using the holes provided in the base.
•
Base should be raised off the floor approximately ½” to allow room for the cover to be removed for cleaning.
• Attach door switch magnet to door in orientation shown in instruction sheet.
•
Use 2 screws to attach magnet to door.
Note: Holes for attaching the base to the wall located on the door edge side are accessible thru slots punched in the
base.
•
Units are designed for installation on the hinge side of doorjamb inside the walk-in compartment.
Place mounting base so that the edge is flush with the inside doorjamb. When mounted with the cover the edge of the
door opening should be flush with the edge of the Kolpak Air Shield cover.
Note: Mount in a manner to prevent any sharp edges from being exposed beyond the door opening.