Page: 2 of 5
Thank you very much for choosing a Wel-Bilt™ Product! For future reference, please complete the
owner’s record below:
Model: _______________ Purchase Date: _______________
Save the receipt, warranty and these instructions. It is important that you read the entire manual to
become familiar with this product before using it.
This machine is designed for certain applications only. The distributor strongly recommends that
this machine is not modified and/or used for any application other than that for which it was
designed. If you have any questions relative to a particular application, DO NOT use the machine
until you have first contacted the distributor to determine if it can or should be performed on the
product.
For technical questions and replacement parts, please call 1-800-222-5381.
Specifications
Tabletop Dimensions
20 1/8in.W x 17 3/4in.D x 3/4in. thick
Tabletop Material
3/4in. pressboard
Frame Material
Formed and stamped sheet steel
Table Height
23 3/4in. (minimum)
30 1/4in. (maximum)
Top Shelf Dimensions
15 5/16in.W x 13 1/8in.W x 1/8in. thick
Bottom Shelf Dimensions
19 1/2in.W x 17 3/16in.D x 1/8in. thick
Max. Load Capacity
1000 lbs.
SAVE THIS MANUAL
You will need this manual for the safety warnings and precautions, assembly, operating, inspection,
maintenance and cleaning procedures, parts list and assembly diagram. Keep this manual and
invoice in a safe and dry place for future reference.
WARNINGS & PRECAUTIONS
Warning: Failure to follow these rules may result in serious personal injury!
1.
For your own safety, read instruction manual before using the worktable.
Learn the
application and limitation of the worktable.
2.
Keep work area clean.
Cluttered areas invite injuries.
3.
Dress properly
. Do not wear loose clothing or jewelry as they can be caught in
moving parts.
Protective, electrically non-conductive clothes and non-skid footwear are recommended when
working. Wear restrictive hair covering to contain long hair.
4.
Do not overreach.
Keep proper footing and balance at all times. Do not reach over or across
running machines.
5.
Check for damaged parts
. Before using this worktable, any part that appears damaged
should
be carefully checked to determine that it will operate properly and perform its intended function.
Check for alignment and binding of moving parts; any broken parts or mounting fixtures; and any
other condition that may affect proper operation. Any part that is damaged should be properly
repaired or replaced.
