2
Your Wel-Bilt Heat Gun has been designed for stripping paint, warm heat shrinking and virtually
perform any task where hot air is required. The Wel-Bilt Heat Gun is intended for DIY use only.
Warning!
When using powered tools, basic safety precautions including the following should
always be followed to reduce risk of fire, electric shock, personal injury and material damage.
Read the whole manual carefully and make sure you know how to switch the tool off, in an emergency,
before operating the tool.
The electric motor has been designed for one voltage only. Always check that the power supply
corresponds to the voltage on the rating plate.
This tool is double insulated; therefore no ground wire is required. If the supply cord is
damaged, it must be replaced by the manufacturer or an authorised Service Agent in order to
avoid a hazard.
Using an Extension Cord
Always use an approved extension cord suitable for the power input of this tool. Before use, inspect the
extension cord for signs of damage, wear and ageing. Replace the extension cord if damaged or defective.
When using an extension cord on a reel, always unwind the cord completely. Use of an extension cord
not suitable for the power input of the tool or which is damaged or defective may result in a risk of fire
and electric shock.
1. Keep work areas clean.
Cluttered areas and benches can cause accidents.
2. Consider work area environment.
Do not expose your tool to rain. Do not use your tool in
damp and wet conditions. Keep the work area well lit. Do not use your tool where there is a risk of
causing fire or explosion, e.g. in the presence of flammable liquids and gases.
3. Keep children away.
Do not allow children, visitors or animals to come near the work area or to
touch the tool or power cord.
4. Dress appropriately.
Do not wear loose clothing or jewellery, as these can be caught in moving
parts. Preferably wear non-slip footwear when working outdoors. Wear protective hair covering to
keep long hair out of the way.
5. Head protection.
Always use safety glasses. Use a face or dust mask whenever the operations may
produce dust or flying particles. Wear ear protection whenever the sound level seems uncomfortable.
6. Guard against electric shock.
Prevent body contact with earthed or grounded surfaces (e.g.
pipes, radiators, cookers and refrigerators). Electric safety can be further improved by using a high
sensitivity (30 mA/30 mS) residual current device (RCD).
7. Do not overreach.
Keep proper footing and balance at all times.
8. Stay alert.
Watch what you are doing. Use common sense. Do not operate the tool when you are
tired.
INTRODUCTION
ELECTRICAL SAFETY
SAFETY INSTRUCTIONS
GENERAL SAFETY RULES
Содержание 151606
Страница 7: ......
