Weka 262.2121, Инструкция по сборке, эксплуатации и обслуживанию

Страница: 42 / 100

Techn. Änderungen vorbehalten! Alle Maßangaben sind ca. Maße.

Copyright HRB 3662
10
3.2.Safety information and warnings
Selection of the substrate
The ground under the cabin should be level, horizontal and built up. If your cabin is located near slopes and
basements, you should consult a local builder. Otherwise, there may be a risk of collapse.
Built-up ground must be compressed to ensure that the cabin does not sink, otherwise damage may occur. Any
turf must also be removed.
Space requirements
The space required depends on the size of your cabin. The cabin must always be accessible from the outside
on all sides to allow for inspection, ventilation and protection against weathering. The space required should be
approximately 1.0
– 1.5 m larger than your cabin on all sides.
In order to prevent accidents, we recommend that children be kept out of the direct vicinity during assembly.
During assembly, children under the age of 14 should be kept at least 3 m from the assembly site.
The current occupational safety and accident prevention regulations are to be observed. Information can be
obtained from a builder.
The roof is only to be accessed on load-distributing boards.
When you are working on a roof, avoid the risk of falling by complying with the current accident prevention
regulations (e.g. scaffolding requirements, safety rails).
Agree the required measures and operating conditions with a local builder or competent work safety authority.
Always work with helpers!
When unpacking the loose wooden parts and when assembling the cabin, we recommend that you wear safety
boots and work gloves. When using a drill or saw, you should also wear protective goggles.
Unless stated to the contrary in the product information or static calculations, the roof is to be cleared of snow
loads larger or equivalent to 0.75 kN / m² or approximately 30 cm in depth.
4. Preparation/information for assembly and use
4.1. Transport and storage
The product is delivered stacked on pallets.
After unpacking and checking, handle the parts as follows:
Protect the wood against
long-term, direct sunlight
moisture contact with the ground