WEISS VM25L, Руководство по эксплуатации и информация по безопасности

Страница: 3 / 20

- 2 -
WARNING!
13. Keep children and visitors away. All visitors
Read and understand the entire instruction
should be kept a safe distance from the work area
manual before attempting set-up or
operation of this mill/drill
14 Make the workshop child proof . Use padlocks,
. master switches and remove starter keys.
1. This machine is designed and intended for use
by properly trained and experienced personnel 15. Wear proper apparel. Loose clothing, gloves,
only. If you are not familiar with the proper safe use neckties, rings, bracelets, or other jewelry may
of mill/drills, do not use this machine until proper get caught in moving parts. Non-slip footwear
Training and knowledge has been obtained. is recommended. Wear protective hair covering
to contain long hair. Do not wear any glove.
2. Keep guards in place. Safety guards must
be kept in place and in working order. 16. Always use safety glasses . Also use face or
dust mask if cutting operation is dusty.
3. Remover adjusting keys and wrenches. Before Everyday eyeglasses only have impact
turning on machine, check to see that any adjusting resistant lenses, they are not safety glasses.
wrenches are removed from the tool. accessories may be hazardous.
4. Reduce the risk of unintentional starting. 17 Do not overreach. Keep proper footing and
Make sure switch is in the OFF position before balance at all times.
plugging in the tool.
18. Do not place hands near the cutterhead
5. Do not force tools. Always use a tool at the rate while the machine is operating.
for which it was designed.
19. Do not perform any set-up work while
6. Use the right tool. Do not force a tool or
machine is operating.
attachment do a job for which it was not designed.
. 20. Read and understand all warnings posted
7. Maintain tools with care . Keep tools sharp and on the machine.
clean for best and safest performance. Follow
instructions for lubrication and changing accessories. 21 This manual is intended to familiarize you with
the technical aspects of this mill/drill. It is not,
8.
Always disconnect the tools from the power
nor was it intended to be, a training manual.
Source before adjusting or servicing.
22. Failure to comply with all of theses warnings
9. Check for damaged parts. Check for alignment of may result in serious injury.
moving parts, breakage of parts, mounting, and any
Other condition that may affect the tools operation. 23. Some dust created by power sanding, sawing,
grinding, drilling and other construction activites
10. Turn power off. Never leave a tool unattended. contains chemicals known to cause cancer, birth
Do not leave a tool until it comes to a complete stop. defects or other reproductive harm.
11. Keep work area clean. Cluttered areas and bench 24. Your risk from those exposures varies,
Invite accidents. depending on how often you do this type of work.
To reduce your exposure to these chemicals,
12. Do not use in a dangerous environment. Do not work in a well ventilated are, and work with
Use power tools in damp or wet locations, or expose approved safety equipment
Them to rain. Keep work area well lighted.