Pick-O-Mat • PM1100 / PM1500 • R02-2014
5/44
Introduction
1.1 Definition
1
1
Introduction
1.1
Definition
The Pick-O-Mat is an automatic assembly machine. The axes carry out cycled move-
ments.
Devices for handling loads are mounted to the axes by the customer.
In the following text of the document, the assembly machine will be referred to as
"module".
1.2
Intended use
The assembly is an incomplete machine in terms of Directive 2006/42/EC,
Article 1g and 2g.
The assembly is designed for integration into other machines, into other incomplete
machines or equipment or for connection to them.
It may only be used within the limitations defined in the order characteristics.
Commissioning is prohibited until it has been established that the machine into which the
aforementioned product should be installed is conform with Directive 2006/42/EC and all
other applicable directives governing its use.
Intended use also requires the observance of the included documention and compliance
with the maintenance provisions.
1.3
Non-intended use
Any use of the assembly other than intended is considered non-intended use and is not
permitted.
The assembly should not be subject to loads beyond its maximum capacity.
The assembly is not suitable for use:
•
in wet or damp environments of any kind (water, oils, acids, steam or vapours, etc.).
•
in an environment with gases or radiation.
•
in potentially-explosive atmospheres.
•
in environments that contain swarf.
1.4
Laws / EC Directives / Standards
The assembly is designed and constructed to conform to:
•
applicable laws
•
Directive 2006/42/EC (Machinery Directive)
•
Low Voltage Directive, 2006/95/EC
•
EMC Directive 2004/108/EC
•
and the harmonised standards that we have cited
and meets state-of-the-art technological standards in terms of its construction.
