© COPYRIGHT Weiss Ltd 2020. All rights reserved
Weiss Limited reserves the right to alter designs and specifications
without notice and without obligation
HT125-2
Revision 03.0 210520
COMPLIANCE AND WARRANTY INFORMATION
•
This appliance must be installed by a registered electrician in accordance with the relevant electrical
wiring rules and regulations and a COC is required for a warranty claim.
•
Not for use with a heat pump
•
Do not cover the fan unit with any insulation material
•
Do not completely close off adjustable outlet vents
•
Always install this product with the supplied controller
•
Weiss Limited reserves the right to alter designs and specifications without notice
•
Incorrect wiring or installation is not covered by warranty
•
Full Warranty information is available on our web site: https://www.weiss.co.nz/warranty
OPTIONAL ACCESSORIES
This product has been designed to operate most efficiently with a max of up to 12 meters of ducting.
If you require longer ducting, we recommend that you install a Weiss™
extension kit
–
with joiner and
reducer (Product No HT125-EXT). The maximum effective single length run is 9 metres.
QUESTIONS AND ANSWERS
Q
: Will the air from the outlet feel hot?
A
: It will depend on the available heat from the heat source. An outlet temperature of about 20ºC to 25ºC
is common, but this will not feel warm to your hand. Average skin temperature of your hand is 28-32ºC.
Q
: Do I use the controller supplied.
A
:
Only
use the supplied controller for operation of this system.
Q
: My house has a high stud / is badly insulated, will this product still work?
A
: Yes, but obviously not as well as in a well-insulated low-stud home. It will always take longer to warm a
larger volume room.
IMPORTANT NOTES
•
The unit should be checked annually for correct operation.
•
This controller has been designed to work with Weiss Heat Transfer AC Fans only.
Weiss Limited, 20b Arwen Place, East Tamaki
PO Box 204-120 Highbrook Auckland
New Zealand
Web:
