2-3/8"
(60mm)
or
2-3/4"
(70mm)
1-1/2
(38mm)
hole
2-3/4" (70mm)
1. Install latch and Strike.
Fig. 3
Fig. 1
d.
Leave the bolt in the extended position.
e.
Install strike with two 1-1/2” (38mm) wood screws
(see figure 5).
2. Remove cover and battery case.
2
Area
Crank
a.
Determine your backset, see
figure 1.
b.
If a 2-3/4” (70mm) backset is
required,
extend bolt
and adjust
latch as shown
. (See figure 2).
Fig. 2
Fig. 5
Fig. 4
c.
Install latch, securing with small
wood screws (see figure 3).
Note:
For a 1-1/2” (38mm) diameter
hole, test if latch extends and
retracts smoothly. Area indicated
may require addition clearance for
crank of latch to function properly
(see figure 4).
a.
Remove cover from assem
-
bly by sliding cover up and off,
see figure. 6
b.
Remove the battery case
from interior assembly by lift
-
ing the case up and out and
set aside, see figure 7.
Fig. 7
Fig. 6
Important before proceeding:
1.
Verify that position #2 of the “Settings Switch” is in the
OFF
posi-
tion. (Refer to section 10.)
2.
Work with the door open (away from jamb) to avoid accidental
lock out.
3.
Make sure the bolt is in the extended (locked) position.
Содержание SMARTCODE5
Страница 1: ......
