©
2018 WEINZIERL ENGINEERING GmbH
page 2/2
Control buttons
❼❽
Pressing the "Reset Start" button triggers a bus reset, meaning
the bus voltage will be interrupted. The reset state is automati-
cally terminated after 30 s and the bus voltage is switched on
again. The reset status can be extended by pressing the "Reset
Start" key again (Retrigger) or terminated manually by pressing
the "Reset Stop" key.
During reset, the "Traffic / Reset" LED lights up red.
WARNING
The device may only be installed and com-
missioned by an authorized electrician.
The applicable safety and accident
contraception regulations must be observed.
The device must not be opened.
When planning and installing electrical sys-
tems, the relevant directives, regulations and
regulations of the respective country must be
observed.
This device is permanently connected, so an
easily accessible disconnecting device must
be installed outside the device.
The connector requires a 16A fuse for exter-
nal overcurrent protection.
The performance data are located on the side
of the product.
Datasheet
www.weinzierl.de/en/products/365/datasheet
CE Declaration
www.weinzierl.de/en/products/365/ce-declaration
Weinzierl Engineering GmbH
D-84508 Burgkirchen / Alz
Deutschland
www.weinzierl.de
2018/10/04
