- 8 -
Wiring the Digital Inputs
The IE-SW-PL10M has two sets of digital inputs, DI 1 and DI 2. Each DI
consists of two contacts of the 6-pin terminal block connector on the
IE-SW-PL10M´s top panel, which are used for the two DC inputs. The top
and front views of one of the terminal block connectors are shown here.
STEP 1
: Insert the negative
(ground)/positive DI wires into the
┴
/I1
terminals, respectively.
STEP 2
: To keep the DI wires from
pulling loose, use a small flat-blade
screwdriver to tighten the wire-clamp
screws on the front of the terminal block
connector.
STEP 3
: Insert the plastic terminal block
connector prongs into the terminal block
receptor, which is located on the
IE-SW-PL10M´s top panel.
Communication Connections
Each IE-SW-PL10M switch has 3 types of communication ports:
1 RJ45 console port (RS-232 interface)
7 10/100BaseTX Ethernet ports
3 Gigabit Ethernet ports:
3 10/100/1000BaseTX ports, or 1 10/100/1000BaseTX and 2
1000BaseSFP (mini-GBIC) ports
In this section, we present two types of diagrams—Pinout Diagrams and
Cable Wiring Diagrams—that convey information about the ports and the
cables used to connect the IE-SW-PL10M Series to other devices:
Pinouts
—
The “Pinouts” diagrams display the type of signal passing through
each of the port’s pins.
Cable Wiring
—
The “Cable Wiring” diagrams present standard cable wiring
schemes for cables used to connect the IE-SW-PL10M Series ports to other
devices. These diagrams display three pieces of information:
1.
When building your own cable, refer to the “pin-to-pin” cable wiring
information displayed between the two vertical dashed lines to see
which pin of the connector on the left should be connected to which pin
of the connector on the right.
2.
The information to the left of the left vertical dashed lines gives the
pinouts of the relevant IE-SW-PL10M Series port.
3.
The information to the right of the right vertical dashed line gives the
pinouts of the opposing device’s port.
NOTE
1.
The pin numbers for male DB9 connectors and hole numbers
for female DB9 connectors are labeled on the connector.
2.
The pin numbers for 10-pin RJ45 connectors (and ports) are
typically not labeled on the connector (or port). Refer to the
following Pinout and Cable Wiring diagrams to see how
10-pin RJ45 pins are numbered
