Weidmüller HPG 60, Инструкция по эксплуатации и техническому обслуживанию

Страница: 28 / 34

Operating
28 2635530000/00/10.2018
3.2 Preparation of the conductor
Cut the cable right-angled to the conductor.
1
Remove the isolation of the cable appropriate to the sleeve length (a-
measure) of the cable lug/ connector plus 10 %.
2
Clean the ends of the conductor carefully of any kind of dirt and remaining
oxides.
3
Stranded conductors have to be rounded before crimping.
3.3 Process of crimping
CAUTION
During the piston moves you are in danger of bruising.
1
Insert the connection material between the dies. For this purpose open
the crimp head if necessary. Don’t cant the cable lug or connector be-
tween the dies; cable lug/ connector and crimp head are intended to be
right-angled.
2
Turn the grip (see Figure 1 on page 24) into the position for the pressure
build-up (=>||<=).
3
Some movements of the pump handle will fix the cable lug/connector (see
Figure 1 on page 24).
4
Insert the stripped cable into the sleeve of the cable lug/connector.
5
By further pump movements the process of crimping continues. The
crimping is finished as soon as the automatic pressure limit is activated, a