Weidmuller WAVE TTA, Руководство пользователя

Страница: 41 / 54

TTA Set software
5662300000/01/08.10 41
8.6 Run mode
Start communication with the WAVE TTA
1
Connect the WAVE TTA to a Power supply.
2
Connect the WAVE TTA with the CBX100 USB
or CBX200 USB interface to an USB port.
3
Start the software TTA Set.
4
Input configuration
Select the input value.
5
Output configuration
Select the output value.
6
Alarm configuration
Set the alarm relay behaviour.
7
Send configuration to WAVE TTA
The button "Save to Instrument” transmits the
new configuration to the WAVE TTA.
8
Enter Password
Enter your password (the default password is
0000). To reset a personal password, send a re-
quest with the serial number of the WAVE TTA to
the following e-mail address:
password.tta@weidmueller.com
9
Read Values
With the button "Read Values” the actual values
of the WAVE TTA are displayed in the window
"Running values”.
If the button "Read Continuous” is activated the
values are updated every second (monitoring).
10
Read from Instrument
To check the current configuration in the con-
nected WAVE TTA click on the "Read from in-
strument” button.
Running values
•
Input: WAVE TTA input value in percent.
•
Output: WAVE TTA output value in percent.
•
CJC Temperature: This the temperature in Centi-
grade or Fahrenheit at the cold junction point in
the WAVE TTA.
•
Alarm1: Shows the status of the first alarm relay
- LED = red = relay switched on (alarm)
- LED = off = relay switched off (no alarm)
•
Alarm2: Shows the status of the second alarm re-
lay
- LED = red = relay switched on (alarm)
- LED = off = relay switched off (no alarm)
8.7 Product identification
Unit Type: Description of the module
Serial No.: The serial number is
printed on the side of the
module.
Firmware No.: The firmware number of
the WAVE TTA device
which is connected.
Configured by: The company name of the
person who last config-
ured the module.
Initials: Initials or the name of the
person who last config-
ured the module.
Date: The date when the mod-
ule was last configured
the module.
ID Tag: Typically, the user’s plant
reference
User Reference: User descriptor
Version: The Version of the soft-
ware
Terminals: Shows the terminal num-
ber where the sensor and
output signals are con-
nected.
Table 10 Product identification