8
4.
Insert the connector of the lower wire harness (A)
into the socket of the Upper Wire Harness (13).
The connector should slide easily into the
socket and snap into place. If the connector
does not slide easily and snap into place, turn the
connector over and then insert it.
Make sure that the connector and wire appear as
shown in the inset drawing.
IF THE CONNEC-
TOR IS NOT INSERTED PROPERLY, THE CON-
SOLE MAY BE DAMAGED WHEN THE POWER
IS TURNED ON.
Pull the excess lower wire harness (A) out of
the Mech Assembly (6) and push it and the
Upper Wire Harness (13) into the Upright (3).
Insert the Mech Assembly (6) into the Base (1).
Attach the Mech Assembly to the Upright (3) with
a 1/2” x 3” Carriage Bolt (79) and a 1/2” Nylon
Locknut (78).
Do not tighten the Locknut yet.
Attach the Mech Assembly (6) to the Base (1)
with the four M10 Nylon Locknuts (71).
Tighten the 1/2” Nylon Locknut (78).
5.
Press the Front Leg Foot (29) onto the bottom of
the Front Leg (31).
Note that the front of the
Front Leg Foot is taller than the back.
Attach the Leg Lever Bumper (30) to the Front
Leg (31) with a #8 x 3/4” Screw (104).
Attach the Bench Rail (23), with the hook on the
bottom, to the Front Leg (31) with two 3/8” x 2”
Carriage Bolts (91) and two 3/8” Nylon Jamnuts
(92).
4
3
1
71
79
78
6
71
13
13
13
A
5
92
92
31
31
104
91
Front
29
23
A