10
19. Attach a Pulley Housing (94) to the indicated “U”-
channel on the 10-Pound Center Crossbow (44)
with an M10 x 102mm Button Head Bolt (24), two
Pivot Bushings (74), and an M10 Nylon Locknut
(76).
Wrap the Long Cable (80) around a 90mm Pulley
(28). Attach the Pulley inside of the Pulley
Housing (94) with an M10 x 42mm Button Head
Bolt (71) and an M10 Nylon Locknut (76).
19
24
94
28
80
44
76
76
71
74
74
18. Wrap the Long Cable (80) around a 90mm Pulley
(28). Attach the Pulley and a Pulley Guard (29) to
the indicated M10 x 140mm Carriage Bolt (73)
with an M10 Nylon Locknut (76). Be sure the flat
edge of the Pulley Guard is on the side shown.
18
76
28
80
73
29
Flat
Edge
16
86
72
Rings on
this side
96
95
95
44
36
67
18
Rods
Edges
up
35
18
4
17. Locate the Long Cable (80). Insert one end of
the Cable through the welded tube on the indicat-
ed end of the Cross Tube (11) and then through a
Swivel Arm (22). If necessary, use the tip of a
screwdriver to pull the end of the Cable out of the
Swivel Arm. Be sure the Cable is on the indicat-
ed side of the welded rod in the Swivel Arm.
Insert the Swivel Arm (22) into the welded tube
on the Cross Tube (11). Secure the Swivel Arm
with an M4 x 5mm Screw (104).
Wrap the Long Cable (80) around a 90mm Pulley
(28). Attach the Pulley inside of the Swivel Arm
(22) with an M10 x 42mm Button Head Bolt (71)
and an M10 Nylon Locknut (76).
17
71
22
104
28
80
11
76
Rod
“U”-Channel
16. Locate the Crossbow Fulcrum (18) on the Lat
Tower (4) (see the inset drawing). Slide the
Crossbow Spacer (35) onto the rods on the
Crossbow Fulcrum. Make sure the Spacer is
oriented as shown in the drawing.
Set the Crossbows into the Crossbow Spacer (35)
in the following order: the 10-Pound Removable
Crossbow (67), the 20-Pound Removable
Crossbow (36), an 80-Pound Crossbow (95), the
10-Pound Center Crossbow (44), an 80-Pound
Crossbow (95), and the 40-Pound Crossbow (96).
Make sure the indicated rings are on the side
shown and the arrows point toward the Spacer.
Attach the Crossbow Cover Plate (72), with the
edges up, to the Crossbow Spacer (35) with two
M8 x 19mm Button Head Screws (86).
