6
3
26
5
25
6
25
26
2
2
Adjustment
Holes
4.
Tap a 2mm Thick 60mm Square Inner Cap (43)
into the top of each Front Upright (1).
Attach a Front Upright (1) and two Joint Plates (14)
to the Left Base (6) using four M10 x 78mm Bolts
(25) and four M10 Nylon Locknuts (26).
Do not
tighten the Nylon Locknuts yet. Make sure that
the Front Upright is oriented so the holes near
the bottom of the Front Upright and the holes
in the Joint Plates line up. If they do not line
up, turn the Front Upright upside-down. Make
sure the Front Upright is turned so the adjust-
ment holes are facing the Rear Upright (2).
Attach the other Front Upright (1) to the Right
Base (5) in the same manner.
43
25
5
1
6
14
14
1
26
26
12
26
1
26
25
5
14
14
25
1
4
3.
Identify the two Rear Uprights (2), which are
slightly shorter and have less holes than the Front
Uprights (not shown).
Attach the Rear Uprights (2) to the Left and Right
Bases (5, 6) using four M10 x 78mm Bolts (25)
and four M10 Nylon Locknuts (26).
Do not tight-
en the Nylon Locknuts yet. Make sure the
Uprights are oriented as shown, with the
adjustment holes on the indicated side near
the bottom.
Adjustment
Holes
5.
Attach the Chin-up Bar (12) and two Joint Plates
(14) to the Front Uprights (1) using four M10 x
78mm Bolts (25) and four M10 Nylon Locknuts
(26).
Do not tighten the Nylon Locknuts yet.
6
4
25
25
2
1
1
26
3
26
2
21
6.
Press a 1.5mm Thick 60mm Square Inner Cap
(21) into the Left Frame (3). Attach the Left
Frame to the left Uprights (1, 2) using four M10 x
78mm Bolts (25) and four M10 Nylon Locknuts
(26).
Do not tighten the Nylon Locknuts yet.
Assemble the Right Frame (4) to the right
Uprights (1, 2) in the same manner.
