Weider 831.15969.0, Руководство пользователя

Страница: 9 / 16

9
7. Insert the end of the Seat Bracket (8) into the
Frame (1), and then attach the Seat Frame (6) to
the Frame with an M12 x 100mm Bolt (14), two
M12 Washers (15), and an M12 Locknut (16) as
shown. Do not overtighten the Locknut; the
Seat Frame must pivot freely.
See step 6. Tighten the M8 x 15mm Screws (13).
See the inset drawing. Firmly tighten the other
Adjustment Knob (9) into the Frame (1) and into
one of the adjustment holes in the Seat Bracket
(8). Then, tighten the other Stop Screw (17) into
the end of the Seat Bracket.
8. Attach the Seat (7) to the Seat Frame (6) with
four M8 x 15mm Screws (13) and four M8
Washers (18); start all the Screws, and then
tighten them. To avoid damaging the Seat,
tighten the Screws only until the Seat does
not move or feel loose.
Note: To adjust the angle of the Seat (7), see
ADJUSTING THE SEAT on page 10.
9. Make sure that all parts of the weight bench are properly tightened. Extra parts may be included. Place a
mat under the weight bench to protect the floor.
8
7
15
14
17 9
15
16
8
8
1
6
1
7
6
13
13
18
18
13
18