5.
Insert the Support Rod (14) into a set of holes in
the Uprights (1). Turn the Support Rod so the
locking pin is wrapped around the Upright.
Tighten the M10 Nylon Locknuts (31) and M10
x 19mm Screw (5) used in steps 1–5.
1
14
5
7
6.
Lubricate the M10 x 60mm Bolt (25) with grease.
Attach the Leg Lever (6) to the Front Leg (4) with
the Bolt and an M10 Nylon Locknut (31).
Do not
overtighten the Locknut; the Leg Lever must
be able to pivot easily.
7.
Slide a Pad Tube (12) into the Leg Lever (6).
Slide two Foam Pads (13) onto the ends of the
Pad Tube.
Make sure the Foam Pads are ori-
ented as shown.
Repeat this step with the other Pad Tube (12).
6
13
13
12
12
Locking
Pin
25
31
Lubricate
6
4
6
7
8.
Insert a Weight Rest (15) into an Upright (1). Turn
the Weight Rest so the locking pin is wrapped
around the Upright.
Repeat this step with the other Weight Rest
(15).
15
15
Locking
Pin
1
8
