17
39. Lightly apply soapy water to the inside of a
Long Foam Pad (47). Slide the Foam Pad onto
the Right Butterfly Arm (34).
Repeat this step with the Left Butterfly Arm
(33) and a Long Foam Pad (47).
34
47
47
33
39
37. Attach the Low Cable (75) to the Rear Base
(25) with an M10 x 68mm Bolt (85), two 16mm
x 22mm Spacers (82), two M10 Washers (83),
and an M10 Nylon Locknut (80).
25
82
83
85
75
37
38
45
96
96
26
87
87
38. Attach the Rack Backrest (45) to the Center
Upright (26) with two M6 x 63mm Screws (87)
and two M6 Washers (96).
40. Make sure that all parts have been properly tightened. The use of the remaining parts will be explained in
ADJUSTMENT, beginning on the next page. Before using the weight rack, pull each cable a few times to
make sure that the cables move smoothly over the pulleys. If one of the cables does not move smoothly,
find and correct the problem.
IMPORTANT: If the cables are not properly installed, they may be dam-
aged when heavy weight is used. See the CABLE DIAGRAM on page 20 for proper cable routing. If
there is any slack in the cables, you will need to remove the slack by tightening the cables (see page
21).
82
83
80
