Q
UICK
S
TART
G
UIDE
www.wegener.com
622 QSG-800067-02 Rev. B.fm
3
Front and Rear Panel Views
The front and rear panels of the
iPump 622
are shown in Figures 1 and 2.
Figure 1: iPump 622 Enterprise Media Server Front Panel
Figure 2: iPump 622 Rear Panel and Connectors
Rear Panel Connections
For
iPump 622
setup, properly connect the rear panel ports with the cables as detailed below. See the iPump
Reference Manual for complete connector and signal details.
Connect the L-band output from your antenna's LNB to the iPump's
RF input port
[950 to 2150
MHz; female Type F connector with extender cable attached or BNC connector if your unit has the
optional ASI input.]
Connect a suitable monitor to the iPump's
audio port
. [An optional, auxiliary audio port is also avail-
able. A 1/8-inch stereo output jack is the connector for each audio port, but a 1/8-to-RCA adapter is
included in the accessories bag.]
Connect a suitable video monitor to either the iPump's
video port
or the
TV OUT port
. [Video port is
a female, 4 pin mini DIN (S-video) connector. An SVD-to-RCA adapter is included in the accessories
bag.] The Normal/Bypass switch must be in the Normal position disabling the TV OUT port. To use
the
TV OUT port
, the switch must be in the Bypass position, disabling the Decoder 1 Video Port.
[Use the Channel 3/4 RF Modulator switch to select the appropriate output.]
NOTE:
If your
iPump 622
is equipped with two decoders, then repeat the connections for the
audio & video ports.
Connect your LAN line to the iPump's
Ethernet port
[10/100baseT; female RJ-45 connector.]
The
Alarm port
on the rear panel may be used to provide a contact closure during alarm conditions
or on command from Compel.
RF
input
port
audio ports
video ports
alarm
port
modem
port
ethernet
port
ANT
IN
port
TV
OUT
port
