weedingtech Foamstream M600, Руководство пользователя, Страница: 16 / 39

M600 – User manual – English (EU) – 16/05/2018 - ISSUE 3
16
7 Start procedure
✓
Complete pre-start checks (see section 6)
✓
Press and hold priming button on regulator
✓
Start the generator by either:
• Turning the key to position E and release to
position D when engine starts (see
• Figure
11
) or
• Turn the key to position D and double press and
hold ON on the remote
✓
Turn the isolator switch to position A (see
✓
Figure 11), the PLC screen should illuminate (see Figure
12)
Figure 11 - Details of the switches of the front panel
✓
The reset indicator (blue light) lights up and FAULT will
appear on the top right hand corner of the PLC screen
✓
Press the RESET button (blue button on the front panel,
see Figure 5), the FAULT indicator goes out and you
should see the screen represented in Figure 12
✓
Wait a few seconds before requesting air bleed: buttons
1 or 2 in Figure 12
If you have disconnected the water tank or are starting
for the first time of the day, please use “ Air bleed
Total ”
If you just took a break or want to perform an additional
air bleed, plea se select “ Air bleed Partial ”
When bleeding the machine, the trigger must be
pushed to allow water to flow out of the lance. Failure to
do so will cause the machine to display a fault message.
✓
Once button 1 or 2 is pressed the bleed screen
represented in Figure 13 will appear.
✓
Wait until the purge is completed. A new screen will
appear, represented in Figure 14.
✓
Press START , the button turns green and the screen
represented on Figure 15 will appear.
✓
The amber HEATER light will illuminate and the red
FAULT button should go out. This indicates that the
boiler has switched on and is heating the water
✓
The green READY light will illuminate when the M600
has reached operating temperature and the system is
ready for use (2 – 4 minutes).
AFTER A COLD NIGHT (BELOW 0 DEGREES CELSIUS),
LET THE GENERATOR RUN FOR 15 MINUTES TO WARM
UP THE MACHINE BEFORE STARTING THE PUMP OR
BLEEDING THE UNIT