weedingtech FoamStream M1200, Руководство пользователя, Страница: 15 / 36

M1200 – User manual – English (EU) – 01/03/2018 - ISSUE 2
15
6. Start procedure
✓
Complete pre-start checks (see section 5)
✓
Start the generator by turning the key in a clockwise
direction to position ‘B’, release to position ‘A’ when the
engine starts (see
Figure
11)
✓
Turn the isolator switch to position ‘B’ (see
Figure
11), the
PLC screen should illuminate (see Figure 12
)
Figure 11 - Details of the switches of the front panel
✓
The reset indicator (red light) lights up and ‘FAULT’ will
appear on the top right hand corner of the PLC screen
✓
Press the ‘RESET’ button (red button on the front panel,
see
Figure 5
), the ‘FAULT’ indicator goes out and you
should see the screen represented in Figure 12
✓
Wait a few seconds before requesting air bleed: buttons
‘1’ or ‘2’ in Figure 12
If you have disconnected the water tank or are starting
for the first time of the day, please use “ Air bleed full ”
If you just took a break or want to perform an additional
air bleed, please select “ Air bleed partial ”
When bleeding the machine, the trigger must be
pushed to allow water to flow out of the lance. Failure to
do so will cause the machine to display a fault message.
✓
Once button ‘1’ or ‘2’ is pressed the bleed screen
represented in Figure 13 will appear.
✓
Wait until the purge is completed. A new screen will
appear, represented in Figure 14.
✓
Press ‘START’, the button turns green and the screen
represented on Figure 15 will appear.
✓
The amber ‘HEATER’ light will illuminate and the red
‘FAULT’ button should go out. This indicates that the
boiler has switched on and is heating the water
✓
The green ‘READY’ light will illumin ate when the M1200
has reached operating temperature and the system is
ready for use (3
– 5 minutes).
AFTER A COLD NIGHT (BELOW 0 DEGREES CELSIUS),
LET THE GENERATOR RUN FOR 15 MINUTES TO WARM
UP THE MACHINE BEFORE STARTING THE PUMP OR
BLEEDING THE UNIT