3
Installation Manual
© 2017 Water Engineering Corporation
Before you begin, make sure the installation kit and tools are complete and ready to use.
Tools required for installation:
utility knife, Phillips screwdriver, hammer, adjustable
wrench, Teflon seal tape, electric drill, and drill bits (1/8”, 1/4” and 7/16”).
Important Note:
Feed Water Quality - Reverse osmosis drinking water systems are not
intended to be used for the treatment of water that is microbiologically unsafe or of
unknown quality. If the feed water quality is unsafe or unknown, have a sample of the
water tested by a qualified laboratory or agency and implement the necessary measures
to ensure a safe water supply.
Check with Local Codes - Some codes may require installation by a licensad plumber;
check with the local plumbing authority prior to installation.
Air Gap - An Air Gap (not included) should be installed prior to the drain to prevent
backflow of contaminated wastes from the drainpipe.
Drain Connections - Some state orlocal codes may require that the drain saddle be
served by a trap other than the one serving the garbage disposal. Before making a
connection, please check with code authorities.
Before you Begin - Important Notes
Do not use water that is microbiologically unsafe or of unknown quality
without adequate disinfection before or after the system.
CAUTION
Before Installation
Fig. #2
