Wechillit FKG370, Инструкция по эксплуатации

Страница: 4 / 9

3
7. INSTALLATION
See drawings page 5.
Install the cabinet in a dry place and so
that it is not exposed to direct sunlight or
any other source of heat.
Place the cabinet in a level position. This is
easily achieved by adjusting the adjustable
feet at the front edge of the base. The
cabinet may not rest against a wall on its
hinged side. When placing the cabinet on a
carpet or on a wooden floor you should
adjust it once more after some time as the
cabinet might settle in soft foundations.
If you want to build the appliance into a cup-
board you must consider 3 factors:
1. There must be space above the
appliance in order to make the cooling
system work satisfactorily. - Fig. 2a,
page 6.
2. When the door is opened the appliance
takes up more room in the width and
therefore the door must either be placed
outside the cupboard or there must be
a space of at least 1,5 cm at the hinge
side. - Fig. 2b and 2c, page 6.
3. The distance to the wall at the hinge
side must be of a sufficient size. - Fig.
2d, page 6.
Furthermore is it possible to build together
two appliance. - Fig. 3, page 6.
If the wine cooler is to be placed next to
another unit, a 25 mm gap must be left.
It is safest to place the earthed wall socket
above the appliance and at least 2.0 m
above the floor. Any local installation rules
for appliances of this kind must be
observed.
During a storm the electricity supply might
be cut off.
You should be aware of this when installing
the appliance in weekend cottages or
elsewhere where you would not
immediately observe that the power has
been cut off. Construction and details in
the accessories are subject to alteration
without previous notice.
8. CHANGE OF HINGE SIDE
Follow the instructions below if you wish to
install the door hinges at the opposite side.
See the drawings on page 7.
Dismantle the top panel cover - fig 1 and 2.
Dismantle the top hinge. To be used later as
bottom hinge at the opposite side - fig 3.
Dismantle the door and its bushing.
Dismantle the bottom hinge - fig. 6.
Place the tension disk and the counter nut
for the hinge pivot on the new bottom hinge.
Mount the door anew.
Tighten the counter nut at the bottom.
Tighten up all nuts.
Mount anew top panel cover and skirting
board cover
9. LIGHTING FIXTURE
See the drawing on page 7.
1. Pull the screen to the left.
2. Pull down the right side of the screen
and take it out.
- Remove the strip - possibly with text - by
pulling it out of the tracks along the whole
length of the profile.
- The fluorescent tube can be replaced.
The mounting is performed in reverse order.
The glow switch can be replaced without
removing the screen.