manual Webheat Control P30 EN.docx
www.webheat.eu
Front Panel:
1.
Temperature display
2.
Temperature sensor number
3.
Entry to the parameter menu
4.
Temperature setting button
5.
Value decreasing button
6.
Value increasing button
7.
Temperature setting signalling
8.
Output 1; lights: Relay 1 active
9.
Output 2; LIGHTS: min or max temperature value exceeded (see F15 or F16)
10.
Emergency states signaling
Temperature setting:
1.
Push the button Set for 2 seconds.
2.
Using UP or DOWN buttons to set the desired temperature value.
3.
Confirm the set with SET key.
Remarks:
-
to cancel the setting, press the M button in any time.
-
the setting change can be limited by F13 and F14 parameters.
Parameters programming:
1.
Enter the menu holding M key for 5 seconds until F10 command displays
2.
If the access is protected PAS command displays. Using UP, DOWN and SET
buttons, enter the password and confirm with SET key.
3.
Using UP or DOWN key to choose the parameter you want to change and enter
with SET key.
4.
Using UP or DOWN button to set the desired parameter value.
5.
Using SET key to confirm the new parameter value and return to the parameter
list.
6.
Finish programming pressing M button or enter the END command and press
SET key or wait 30 sec without pressing any button.
Remarks:
-
Press M button to cancel the parameter setting.
-
Hold UP or DOWN button for at least 1 sec to improve quick increasing and
decreasing of setting values.
