WebGate C1080BL-IR18-AF, Инструкция по установке и эксплуатации

Страница: 6 / 64

5
2. Configure PTZ settings such as Protocol(C1080), Baudrate, Address in DVR.
3. Run HD Camera Upgrade program then enter IP address of DVR which is connected to
camera and enter channel number of camera.
- PC for Firmware upgrade and DVR need to be connected with network.
- HD Camera Upgrade program and firmware can be downloaded from Webgate ’ s
website.
4. Select a Firmware and click Load button. Then firmware upgrade will proceed and the
camera will reboot automatically after completion.
- Image will stop until boot completes.
- If image stops over 1min, select Aux1 of selected channel to reboot camera again.
5. After firmware upgrade, DVR or CMS(Control Center) can change camera configuration
by controlling camera ’ s OSD menu remotely.
How to use OSD menu
OSD menu function
If pressing MENU button over 1 sec continuously, OSD menu will be shown.
- If OSD menu is not closed, it will be closed automatically in 1 minute. (Changed
configuration value will not be saved)
- Bold font with underline means factory default.
OSD MENU Function
ADJUST
FOCUSING
If pressing Menu button less than 1 sec, Adjust Focusing mode will be
activated.
- After Focus Adjustment, if you press the MENU button again, Adjust
Focusing mode will be closed.
- If you do not exit the menu, it will be closed automatically in 1 minute.
LENS DC(AF Model) This is DC Iris Auto Focus lens which can make a focus
either by automatically and manually.
- Autofocus : Autofocusing by joystick one-click.
- Zoom(AF) : Autofocusing after Tele, Wide action.
- Manual : Move joystick to up(Tele), down(Wide),
left(Near),right(Far) to adjust angle and
focus manually.