www.weber.com
®
12
Gas iNsTrucTioNs
A
B
C
D
E
snap iGnition operation
m
always open the lid before igniting the burners
Each control knob has its own igniter electrode built in. To create a spark you must push
the control knob in
(a)
and turn to “START/High”
(b)
.
This action will generate gas flow and a spark to the burner lighting tube
(C)
. You will
hear a “snap” from the igniter. You will also see a 3˝ - 5˝ orange flame coming from the
burner lighting tube at the left side of the burner
(d)
.
Continue to hold the burner control knob in for two seconds after the “snap”
. This
will allow gas to flow completely down the burner tube
(e)
and insure ignition.
Check that the burner is lit by looking through the cooking grates. You should see a
flame. If burner does not light on first try, push control knob in and turn to OFF.Repeat
lighting procedure a second time.
m
warninG: if the burner still does not light, turn the burner
control knob to “off” and wait 5 minutes to let the gas clear
before you try again or try to light with a match.
