SUMMIT 475 & 675
Natural Gas Barbecues
Summit 475 NG
Summit 675 NG
THIS GAS APPLIANCE IS DESIGNED FOR OUTDOOR USE ONLY.
G
ENERAL
I
NFORMATION
BUILT-IN CONSTRUCTION GENERAL INFORMATION
WARNING
A Weber-Stephen Products Co. insulated sleeve must be used for any built-in installation.
CLEARANCE FROM COMBUSTIBLE SURFACES OR
STRUCTURES
Warning: Clearance from the outside walls of the sides and
back of the insulated sleeve must be a minimum of 24
inches from a combustible surface. Measure from the
outside wall of the insulated surface to the combustible
surface. Figure 2. Refer to “Install Gas Supply” on page 2
before starting installation.
Figure 2
Figure 1
CLEARANCE FROM NON-COMBUSTIBLE SURFACES OR
STRUCTURES
Warning: Clearance from the outside walls of the sides and
back of the insulated sleeve must be a minimum of 6 inches
from a non-combustible surface. Measure from the outside
wall of the insulated surface to the non-combustible
surface. Figure 1. Refer to “Install Gas Supply” on page 2
before starting installation.
COMBUSTIBLE SURFACE
24 inches
24 inches
24 inches
NON- COMBUSTIBLE SURFACE
6 inches
6 inches
6 inches
WARNING: All countertop finished surfaces must be
constructed of a noncombustible material.
WARNING: All countertop finished surfaces must be
constructed of a noncombustible material.
Countertop
Countertop
Insulated sleeve
Insulated sleeve
LOCATING YOUR BARBECUE
When determining a suitable location for your barbecue installation, give attention to concerns such as exposure to wind, proximity to
traffic paths, and keeping any gas supply lines as short as possible. Never locate the Weber Gas Barbecue in a garage, breezeway,
shed, under an unprotected overhang, or other enclosed area. Locate the barbecue and structure so there is enough room to safely
evacuate the area in case of a fire.
THIS GAS APPLIANCE IS DESIGNED FOR OUTDOOR USE ONLY.
98251 3/99
