Weber Q 300 Series, Руководство пользователя

Страница: 36 / 40

36
WWW.WEBER.COM
ANNUAL MAINTENANCE
5
6
7
11
9
10
12
13
8
Clean Burner Tubes
You will need: A flashlight, a wire (a straightened-out coat
hanger), a suitable stainless steel bristle brush, and a soft
bristle brush (toothbrush) .
A) Look inside each burner tube with a flashlight (5) .
B) Clean any debris or blockage from the inside of the
burner tubes with the wire (6) .
C) Check spider/insect screens at the ends of the burner
tubes and clean them using the soft bristle brush (7) .
m
CAUTION: Do not clean the spider/insect
screens with hard or sharp tools. Do not
dislodge the spider/insect screens or
enlarge the screen openings.
D) Use the steel bristle brush to clean the outside of the
burner tubes . This is done to make sure all burner
ports (openings) running along the length of the
burner tubes are fully open (8) .
m
CAUTION: Do not enlarge the burner
ports when cleaning.
Reinstall Burner Tubes
You will need: A 3/8" nut driver .
A) Carefully slide the inside burner tube back into hole in
right side of cookbox (9), aligning burner tube opening
with valve orifice (10) .
B) Reinstall screw that holds the inside burner tube to
the cookbox .
C) Repeat this procedure for the outside burner tube
(11) .
m
CAUTION: The burner tube openings (12)
must be positioned properly over the
valve orifices (13).
m
WARNING: You should check for
gas leaks every time you disconnect
and reconnect a gas fitting. Refer to
“CHECKING FOR GAS LEAKS.”
D) Replace cookbox components .