B-4
Add cooking box (assembly)
You will need: frame assembly, cooking box
(assembly), 2 inch bolt, nylon washer, keps nut, pliers
and a 7/16 inch or adjustable wrench.
Place the cooking box (assembly) in the frame
assembly so the burner tubes(1) are under the frame
brace(2).
Slide the cooking box (assembly) to the left within the
frame assembly. Add the nylon washer to the bolt.
Insert the bolt through the cooking box and frame with
the head of the bolt outside the box. Add the keps nut.
Tighten by holding the bolt with pliers while you tighten
the nut with a wrench.
Your Weber Gas Grill Manifold assembly consisting of
gas manifold, valves and gas burners has been factory
assembled, pressure- and flame- tested. As a safety
precaution, we recommend you check the burner
alignment:
1) Are the ends of the burners under the washers at
the left rear and left front of the cooking box? The
screws are only guides. Do not tighten.
2) Do the valves fit into the ends of the burners?
3) Are the wing nuts under the burner assembly hand
tight? Do not tighten with pliers.
If you answered YES to 1, 2 and 3, the burners are
correctly aligned. If you answered NO, the burners are
misaligned. Contact the Customer Service
Representative in your region using the contact
information sheet provided with your manual. Do not
use grill.
(1)
(2)
(1)
(2)
(3)
