Weber Genesis 2300 NG, Руководство пользователя

Страница: 18 / 32

18
Figure 21
Hair pin cotter
Hinge pin
Figure 22
Insert in
frame brace
Tool holders
(a)
(b)
Control panel
Phillips screws/
washers
Step 16
Install lid
You will need: lid, two hinge pins and two hair pin cotters.
Set the lid in place. Align the hinges at the rear of the
barbecue. Insert hinge pins from the outside. Insert hair pin
cotters into the small holes in the hinge pins. Figure 21.
Step 17
Install tool holders, control panel and burner
control knobs
You will need: three tool holders, control panel, two
Phillips screws/washers, a Phillips screwdriver, and three
burner control knobs.
Hook the tool holders over the frame rail. Figure 22.
Set the control panel in place over both frame braces.
(Hold the Crossover Ignition button up while setting the
control panel in place.) Line up the holes in the control
panel with the holes in the inserts in the frame brace.
Insert screws and tighten with a Phillips screwdriver until
snug. Do not overtighten. Figure 22 (a).
Push on the burner control knobs. Figure 22 (b).
Crossover
Ignition
Button