Integrated LCD Systems
ENGLISH
BASIC OPERATION GUIDE
WebDT Integrated LCD Systems
ENGLISH
4
signage dtri com
DT Research, Inc.
2000 Concourse Drive, San Jose, CA 95131
h
tt
p://www.dtresearch.com
Copyright © 2011, DT Research, Inc. All Rights Reserved. DT Research and WebDT are registered trademarks of DT Research, Inc.
INTRODUCTION
Thank you for acquiring the WebDT Integrated LCD System, a 15-inch/ 17-inch/ 21.5-inch TFT
display-integrated, thin compu
ti
ng pla
tf
orm, o
ff
ering adaptability to moun
ti
ng con
fi
gura
ti
ons and
applica
ti
ons, including informa
ti
on appliance, thin client for server compu
ti
ng, and disk drive-
equipped op
ti
ons.
Please take a few moments to review the contents of this document to ensure that the setup and
startup proceed smoothly. The WebDT Integrated LCD System is ready for use, out of the box, in its
default con
fi
gura
ti
on when powered by the power source provided. The following discussion o
ff
ers
guidance on the hardware elements and features of the WebDT Integrated LCD System. Please refer
to your device provider for informa
ti
on pertaining to the so
ft
ware opera
ti
ng system or so
ft
ware
applica
ti
ons.
Package Contents
O
•
ne WebDT Integrated LCD System
A
•
C/DC power adapter with power cord
B
•
asic opera
ti
on guide
Precau
ti
ons
Always exercise care when opera
ti
ng and handling the WebDT Integrated LCD System.
•
Never disassemble any por
ti
on of the enclosure, as this will void any product warranty on the
•
WebDT Integrated LCD System.
Do not use any AC/DC adapter other than the one provided with the device or a replacement
•
acquired from the manufacturer.
I
•
n the unlikely event that smoke, abnormal noise, or strange odor is present, immediately power
down the WebDT Integrated LCD System and disconnect all power sources. Please report the
problem to your device provider immediately.
BOG081711ILENG
Moun
ti
ng
The WebDT Integrated LCD System is designed to be secured to VESA-compliant moun
ti
ng arms or
stands. This is accomplished by equiping the standard metal base on the rear of the display unit.
The VESA-compliant moun
ti
ng holes at the rear of the device will mate with VESA mounts or arms
to meet the requirements of the deployment.
Remove the detachable base by pressing
1.
upward to remove the cover, then unscrewing
the four screws a
tt
aching the base to the
display.
A
tt
ach the new VESA-compliant moun
ti
ng
3.
device or stand to the display.
The display without the base.
2.
The display successfully mounted on a
4.
VESA-compliant moun
ti
ng arm.
