Webb WER19A, Руководство оператора и список запасных частей, Страница: 5 / 14

• The mower will now recycle the chopped grass into the lawn surface.
• To mulch efficiently only cut one third of the length of the grass.
SET UP YOUR MOWER
IMPORTANT : Unfold the handle carefully so
as not to pinch or damage the control cables.
1. Depress the Operator Presence Control Bar
(OPC) and raise the handles until the lower handle
section locks into place at the mowing position.
2. With the Operator Presence Control Bar still
depressed raise the upper handle section into place
on the lower handle and tighten both handle knobs.
Operation
Operator Presence Control (OPC) Bar - must be held down to the handle to start the engine. Release to
stop the engine.
Starter rope - used for starting engine.
Drive control lever - used to engage self- propelled motion of the lawn mower.
LAWNMOWER ENGINE SPEED
The engine speed was set at the factory for optimum performance. Speed is not adjustable.
DRIVE CONTROL
z
The drive is controlled by holding the Operator Presence Control bar down to the handle and pulling
the drive control lever back towards the handle.
z
Forward motion will stop when the operator presence control bar is released. To stop forward motion
without stopping the engine release the drive control lever until the drive control disengages and hold the
operator presence control bar down against handle to continue mowing without the drive.
ADJUST CUTTING HEIGHT
Lower the cutting deck for a low cut and raise the deck for a high cut; adjust cutting height to suit your
requirements. Medium position is best for most lawns.