Webb WEER38, Руководство оператора, Страница: 12 / 20

At the start of each season, check the condition of the blade, the connection cable and all
electrical connections.
If repairs are necessary, please contact one of our customer service centr
e
s.
Use only original spare parts for maintenance work.
10.2 Storage:
Always clean your mower before storage. Store your mower in a clean, dry environment.
To avoid mould on remaining contents, make sure the grass bag is empty and dry.
You can fold the handle
s
to save space, loosen the 2 clamps on each side of the handle and
bend the upper handle part towards the front of the machine.
Long te
rm
storage : apply some environmentally friendly oil on the mower blade to prevent it
from rusting.
Have your blade sharpened after mowing season, so your machine is ready for
the new
season.
11 TROUBLE SHOOTING
Warning: Switch off and remove
the
plug from
the
mains before performing any action
repairs
.
SYMPTOM POSSIBLE CAUSE REMEDY
Handle not in
position Lower handle knobs not
seated properly.
Handle knobs not tightened.
Adjust the height of the handle and
make sure the knobs are seated
properly.
Tighten handle knobs.
Mower not
starting
Power
cord not
connected to the mower
plug
Power
cord not
connected to power source.
Tripped circuit breaker in the
house.
Motor control switch
defective.
Reconnect the cord and use the cord
retainer to keep the cord close to
the
motor/blade control.
Connect the
power
cord to a live
230V, 50Hz AC receptacle.
Reset house circuit breaker. If it trips
again, call a qualified electrician.
Have motor control switch replaced
by an authorized service centr
e
.
Mower
is
cutting
grass
unevenly
Lawn is rough , uneven or the
cutting height is not set
properly.
Raise the cutting height to a higher
setting.
Mower not
mulching
properly Wet grass clipping sticking
to the underside of the deck. Wait until the grass dries before
mowing.
Mower hard to
push High grass, rear of mower
housing and blade dragging
in heavy grass, or cutting
height too low. Raise
the
cutting height.
Mower
vibrating at
higher speed
s
Blade is unbalanced.
Bent motor shaft.
Have repair
ed
by an authorized
service
centr
e
before restarting.
Stop the motor, disconnect the power
source, and inspect for damage.
Have repair
ed
by an authorized
service
centr
e
before restarting.
Important: Wear safety gloves
when handling the blade.
At the end of the season, perform a general inspection of your lawnmower and remove any
grass and dirt which may have accumulated.
9