Webb 1938292001, Оригинальное руководство пользователя

Страница: 13 / 32

OPERATION
ENGINE STARTING & STOPPING PROCEDURE
NOTE:
Starting an engine without engine oil or fuel can seriously damage the machine.
STARTING THE ENGINE (COLD)
1. Push the red engine primer bulb on top of the air filter housing a maximum of three times.
2. Move throttle control lever to the fast (Rabbit) position.
3. Pull the OPC/Brake lever towards the main handle. Do not let go.
4. Grab the recoil starter handle and pull lightly until resistance is felt, then pull rapidly.
5. The engine should start.
6. Rehouse the recoil starter handle. Do not let it go until housed to prevent damage.
7. Adjust the throttle to required engine speed.
8. If the engine does not start, run through from step 2 again.
PRIMER BULB
POSITIONED ON FRONT OF THE AIR FILTER
HOUSING.
PRESS A MAXIMUM OF THREE TIMES
FUEL & OIL
ALWAYS REFER TO THE SEPARATE ENGINE MANUAL SUPPLIED WITH YOUR MACHINE.
WARNING
YOUR MACHINE IS SUPPLIED WITHOUT ENGINE OIL OR PETROL
Operating the engine with insufficient oil, can have catastrophic consequences. Any failure caused by
insufficient oil, will not be covered by the manufacturer’s warranty.
READ INSTRUCTIONS CAREFULLY.
Fuel & its vapors are very flammable. Do not use or fuel the machine near a flame, sparks or while smoking.
Allow the engine to cool for more than 3 minutes, before re-fueling. Never fuel the machine with engine
running. Fuel the engine at least 15 metres away from your work area. Always fuel your machine outdoors.
IMPORTANT:
Fuel which is older than 30 days old can become stale and cause acid & gum deposits in the fuel system or
essential carburettor components. This could result in starting issues which would not be covered by your
manufacturer’s warranty.
Ensure that any stored petrol is clearly marked in a separate appropriate canister for a maximum of 30 days,
if not mixed with a fuel additive. If the machine is not going to be used for a long period, drain the fuel tank,
start the engine and drain the carburetor of any remaining fuel.
To keep fuel fresh, we recommend you use SURE-START FUEL ADDITIVE (HP-199) from Handy Parts. A fuel
additive added to your fuel at the time of purchase, will help make your machine easier to start, extend the
shelf life of your fuel mixture for up to two years, keeps the carburettor & engine clean, plus reduces emissions
and increases fuel economy. A 250ml bottle of SURE-START FUEL ADDITIVE will treat 25 litres of fuel. Only use
4-stroke SAE30 or 10W/30 air cooled lawnmower engine oil. DO NOT USE automotive or marine oil.
FUELING THE MACHINE
Place machine onto a solid flat surface, ensure the engine is not running. Let the engine rest for a minimum of
two minutes. Fill the fuel tank outdoors or in well-ventilated areas.
Unscrew the fuel cap slowly and fill the fuel tank with clean, less than 30 days old unleaded petrol with an
Octane rating of 87 (91 RON) or higher. Fill to a maximum of 80% capacity. This will allow the fuel tank to
expand. Fasten the fuel cap tightly, being careful not to cross-thread. This will also prevent loosening through
vibration during use. Wipe away any spillage, with an appropriate material. If the machine has continued
leaks, the product should not be started. Never use the machine with damaged ignition cable or spark plug
cap, as there is a risk of sparks.
WARNING
Fuel and its vapors are extremely flammable and explosive. Fire or explosion can cause severe burns or
death.
INSTRUCTION MANUAL