Webb 1938262001, Оригинальное руководство пользователя

Страница: 15 / 32

OPERATION
THE BATTERY MUST BE FULLY CHARGED BEFORE THE FIRST USE OF THE PRODUCT. SEE STARTING & STOPPING
WARNING
The tines start rotating immediately after the tiller is switched on. Keep hands and feet away from the tines.
1. To switch ON, hold the tiller firmly with two hands. One hand should be placed on the top trigger handle,
with your other hand firmly holding the front handle. Always ensure the tines are not touching any surface
when starting the machine.
2. Press the safety button, then squeeze the trigger. The tines will then rotate. Once the tiller has started, you
can release the safety button, whilst still holding the trigger.
3. To switch OFF, simply release the trigger.
USAGE
Before use, remove any visible stones or other foreign bodies from the area.
Use the tiller for breaking sod, preparing seed beds and for cultivating gardens and flower beds. The
tiller can also dig small holes for planting saplings or potted plants.
For breaking sod or deep tilling, allow the tines to pull the tiller forward to the end of your arm’s reach, then
firmly pull it back toward yourself. You will achieve the best results by repeatedly allowing it to move forward
and pulling it back. By pulling the tiller back towards yourself, the tines will dig deeper and more aggressively.
WARNING
To prevent tripping, take extra precautions when moving backwards and when pulling the tiller back towards
yourself.
If the tiller digs deep enough to stay in one spot, gently rock it side to side until it starts moving forward again.
When working on inclines, always stand diagonally to the incline to retain a firm, safe footing. Do not work on
extremely steep slopes.
SAFETY BUTTON
TRIGGER
BATTERY & CHARGER
By pressing the button on the battery, the LED display will show the battery capacity.
LED LIGHTS BATTERY STATUS
LED x4 Battery is 75-100% charged
LED x3 Battery is 50-75% charged
LED x2 Battery is 25-50% charged
LED x1 Battery is 0-25% charged
BATTERY CHARGER
WARNING
Risk of electric shock and short circuiting. Use approved and intact wall sockets. Make sure that the cable is
not damaged. Replace cable if it appears to be damaged in any way
CONNECTING CHARGER TO POWER SOURCE
Connect the battery charger to the voltage
and frequency specified in this manual and
on the rating plate. Put the electric plug in an
earthed socket-outlet. The LED on the
battery charger lights up green.
CONNECTING CHARGER TO BATTERY
⚫
The battery must be charged before using it
the first time.
⚫
Install charger on the top of battery and
push until the charger connects firmly with
the battery.
⚫
The LED will turn RED on the charger, when
the battery is connected to the battery
charger.
⚫
When the LED on the charger turns to
GREEN, the battery is fully charged.
⚫
Disconnect the power plug. Never pull the
power cable of the charger to disconnect it
from the wall socket.
⚫
Remove battery from battery charger.
NOTE:
Lithium-ion batteries can be charged at whatever charging level. The charging process can be cancelled or
started whatever the battery’s charge level is.
INSTRUCTION MANUAL