Webasto Thermo Call TC3, Руководство по установке

Страница: 10 / 15

Thermo Call TC3
10
Connection of an alarm system
installed in the vehicle (option)
It is possible to connect an alarm system in
the vehicle. The vehicle owner receives a text
message when the alarm system is triggered.
Insert the wire in Pin 7 of 12-pin connector
and connect it to the output of the alarm
system (must be a +12 V signal).
To define which text message content the
TC3 is to use to inform you, send the
following text message command to the TC3
following commissioning:
1234IBANK:"Entry command" . The entry
command can, for example, be Alarm.
The alarm can be sent to up to 5 phone
numbers. To define which phone numbers
are to be used, send the following text
message command to the TC3:
1234NBANK:XXX:YYY:ZZZ:VVV:WWW
XXX:YYY:ZZZ:VVV:WWW = phone numbers
to be entered by the user, e.g.:
+4366414369912345678:etc.
Connection of an external
temperature sensor (option)
This is required for measuring the
temperature outside the Thermo Call TC3
(e.g. for cargo areas) and for using the
temperature alarm function.
Required material:
-
W bus temperature sensor 9023181A
(not required in combination with Tele-
start T100 HTM)
- Y-adapter 9001505A (only required if a
digital timer 1533 is connected after the
Thermo Call TC3)
- See the Webasto Accessories Catalogue
for any required extensions
Carry out the connection in as shown in the
following drawing and illustrations on the
inner cover pages.
To use the temperature alarm, the phone
numbers to be notified must be reported to
the Thermo Call TC3. To define the phone
numbers, the following text message
command must be sent to the Thermo Call
TC3:
1234NBANK:XXX:YYY:ZZZ:VVV:WWW
XXX:YYY:ZZZ:VVV:WWW = phone numbers
to be entered by the user, e.g.:
+4366414369912345678:etc.
For details, see operating instructions.