Webasto Thermo 90, Руководство по ремонту

Страница: 33 / 53

Thermo 90 8 Servicing
801
8 Servicing
8.1 General
This section describes the servicing procedures that may
be performed with the heater installed.
8.2 Work on the Heater
Prior to performing any work, it is mandatory to disconnect
the vehicle battery main lead. As long as the heater is
in operation or in run-down, the battery main supply must
not be disconnected due to the danger of overheating
resulting in a response of the overheat protection. When
performing extensive repairs on the heater, a complete
removal is advisable. After work on the heating circuit,
a coolant mixture consisting of water and anti-freeze
must be replenished in accordance with manufacturer
instructions followed by a careful bleeding of the heating
circuit.
When performing repairs requiring a relocation of the
installation position, the relevant installation instructions
and the vehicle-specific installation proposal have to be
observed.
8.3 Work on the Vehicle
CAUTION
In the vicinity of the heater, a temperature of 130° C must
not be exceeded under any circumstances (e.g. during
body paint work).