Manual operation | 7
3399682A OI Door Moving System - Pascoe Tenders
5 / 6
7
Manual operation
If necessary, the doors can be operated manually. It depends on
the situation which procedure for manual operation you must
follow.
Both doors can be moved individually.
7.1
Manually moving the door over a
short range (less than 25 cm)
u
Gain access to the desired motor assembly.
WMS000019
Fig. 5
u
Insert the tool for manual operation in the slot in the motor.
u
Turn the tool to close or open the door.
7.2
Manually moving the door over
more than 25 cm
CAUTION
Watch out for entrapment
u
Gain access to the desired motor assembly.
WMS00128A
1
2
3
Fig. 6
u
Disconnect the wiring harness (2) from the motor (1).
u
Remove the 3 nuts and washers (3) from the motor.
u
Remove the motor.
WMS00115A
Fig. 7
u
Push the door to the desired (open or closed) position.
7.3
Reset
After manual operation you must reset the control system.
Reset the system as follows:
ü
Make sure a power source of at least 12 V/20 A per side is
available.
WTNL00014
Fig. 8
u
Press and hold the close button.
– The door closes as far as possible.
u
Release the close button.
u
Press and hold the close button again.
– After approx.. 10 s, the door closes with small steps until
completely closed.
– The motor produces a loud click sound.
u
Release the close button.
– The system has been reset.
8
Annex
8.1
Technical data
Description
Value
Operation
Continuous electric
Power
12 VDC, 20 A per side
