The RFS5 is a wireless rain/freeze sensor operating on a 900 MHz bi-
directional frequency. Maximum range is 1500 feet (457m) Line of
Sight (LOS). The RFS5 is operable with all ProLine® and SmartLine®
models and rmware versions. The RFS and RFSHUB-5 are “pre-
paired” or synced at the factory for your convenience.
Required Hardware:
ProLine or SmartLine® irrigation controller/all models and
rmware versions
RFSHUB-5 wireless communication hub
RFS5 Wireless Weather Station
Step 1: Install the RFSHUB-5
The RFSHUB-5 is the wireless transceiver that communicates with
the RFS5. The RFSHUB-5 is supplied with your RFS5. To install in your
ProLine® controller, open the control panel on the 1600/4800
models. On the 800 model, remove and discard the hub cover panel
from the back of the housing.
Insert the RFSHUB-5 into the mating pin connector holes. Be
careful not to bend the connecting pins. Secure the RFSHUB-5
to the housing with the supplied athead machine screw. The
RF antenna will hang down inside the 1600 or 4800 housing.
On the 800 model, allow the RF antenna to hang underneath
the controller.
Make sure AC power is supplied to the ProLine® controller and
then proceed to Step No. 2.
Step 2: Initializing RFS5 Weather
Sensor
1. While standing in front of controllers, press the rain spindle on
the top of the RFS5 for 15 seconds; then watch the LED which is
visible through the openings in the cover at the bottom of the
RFS5. You will see 4 blinks. All blinks should be Green.
NOTE: The 4th ( nal blink) indicates the strength of the RF
communication. If the 4th blink is Red, you do not have a
satisfactory RF communication. Move the RFS5 to a di erent
mounting location and repeat the diagnostic procedure.
RFS5 Wireless Rain/Freeze Sensor
Installation Guide
