WeatherGuide™ Wired Indoor/Outdoor Thermometer
Model 1710
Instruction Manual
Welcome to the Taylor® WeatherGuide™ System. Simple, reliable, accurate…it allows you to monitor indoor conditions
and read outdoor temperatures from indoors, creating an all-in-one weather display.
BATTERY INFORMATION
YourWeatherGuide™ is powered by 1 CR2025 lithium battery (included). There is a strip under the battery cover to
prevent battery drain in shipping. Please remove the strip before continuing with these instructions.
(You may need to
remove the battery compartment cover to avoid breaking the strip). Also, some models have a static cling label on the lens
to prevent scratching. Please remove before use.
Replace the battery when the readings grow dim or irregular. To replace the battery:
1. Use one 3 volt CR2025 lithium battery.
2. Pull out the battery compartment on the side of the thermometer.
3. Remove the old battery from the compartment.
4. Place the new battery with the “+” sign up into the battery compartment.
5. Push the battery compartment cover back in.
NOTE:
Please recycle or dispose of batteries per local regulations.
WARNING:
Batteries may pose a choking hazard. As with all small items, do not let children handle batteries.
If swallowed, seek medical attention immediately.
PRECAUTION:
Do not dispose of batteries in fire. Batteries may explode or leak. Remove the battery if the unit will not
be used for a long period of time.
DISPLAYING YOUR WEATHERGUIDE
Place the unit indoors in a well-ventilated location away from direct sunlight.
Table top display – Pull out the Table Stand on the back of the unit.
Wall display – use the keyhole on the back of the remote to hang on a wall using a nail or screw (not included).
TEMPERATURE READINGS
Your WeatherGuide™ displays current indoor and outdoor temperatures, as well as the maximum and minimum
temperatures recorded over the last 24 hours.
● Current temperature readings display in the center and the bottom left corner of the LCD screen
(next to the “
” and “
” icons).
● Maximum temperature readings display in the middle screen at the bottom of the LCD screen
(next to the “
” icon).
● Minimum temperature readings display in the right screen at the bottom of the LCD screen
(next to the “ ” icon).
Indoor temperature readings – these are temperatures at the thermometer’s location.
Outdoor temperature readings – these are temperatures measured by the attached sensor probe. Open a window and run
the cable through the opening so that the sensor probe is exposed to the outdoor temperature. Gently close the window to
avoid crimping or severing the cable.
Alternately, the probe may be used to measure temperatures of aquariums, swimming pools, hot tubs, etc. Simply allow
the end of the probe to hang where you wish to measure temperatures.
Temperature readings will update approximately every 10 seconds.
