5
© 2022 Werner Co. Part No. 24-00150DIG REV. A
RACK ASSEMBLY INSTRUCTIONS
STEP 4.
Loosely assemble a 5/16-18 x 7/8" car-
riage bolt, plate, and knob to each of the
Ladder Stops as shown.
STEP 6
-Insert (2) 5/16-18 x 7/8" carriage bolts and plates into bottom of the 1st, 3rd, and 5th crossmembers.
-Insert a Ladder Stop assembly into top of the 2nd and 4th crossmembers. Feel free to tighten the knobs now as they
can be adjusted by hand at any time later.
-Assemble End Rails to Crossmembers using (20) 5/16-18 x 2" button head bolts & (20) bushings. 150 in-lbs or 13 ft-lbs.
-Place Roller Tube between the Bearings and insert a 1/2-13 bolt through each Bearing and thread them into the ends of
the Roller Tube. Tighten until the threads are fully engaged. Do NOT exceed 33 ft-lb.
-Thread a 1/4-20 set screw into each of the holes near the ends of the Roller Tube and tighten them to 76 in-lb to prevent
the 1/2-13 bolts from loosening.
STEP 5.
Align crossmembers to the end rails with the
rounded/blunt end facing the front of the rack
(away from the Roller Brackets).
Front
